Advertisement
Wall Sleeve Brands:
#6 Whirlpool
17 1/8" Deep
Rear Louvers
/
I!
IIIIII
I IIIIIIIII
Top View
1. Redirect the louvers at the back of the wall sleeve as shown
opposite.
The use of pliers is recommended.
2. Cut (2) 17" Tapered
Spacer Blocks as shown below into
two pieces.
17..
3/4"
_k
t
__r
I
Cut Here
i _
\
__
Protection Paper Backing
3. Install to the floor of the sleeve as shown. This helps
induce a rearward
slope on the unit.
4. Attach (1) 1 W' x 3/8" x 25" long seal in the center at the
top of the sleeve.
Remove the backing
paper and press
into position.
5. Attach (2) 1 W' x 3/8" x 14" seals to the left and right
sides of the sleeve.
6. Cut the 1 W' x 3/8" x 25" long seal to 14" long and attach it
to the vertical section of the rear grille as shown.
7. Center unit & gently slide unit into sleeve.
8. Before sliding all-the-way
back, remove 2nd screw from front
on left side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
11. Slide the unit completely
to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
12. Seal & Frame the unit as described
on the last page of
these instructions.
8
Advertisement
