Advertisement
Wall Sleeve Brands:
#2 Fedders
193A '' Deep
Rear Louvers
J
I/
1/1111
I II/111/I/
Top View
1. Redirect the louvers at the back of the wall sleeve as shown
opposite.
The use of pliers is recommended.
2. Attach (2) 4 W'x 3 W' x 1 W' centering/support
blocks one
on each side wall. Place in center of side wall with the
tapered
end facing the opening.
3. Cut (2) 17" Tapered
Spacer Blocks as shown below into
two pieces.
17,,.
I
3/4"
pered Spacer Block
4\
Cut Here
i _
\
Protection Paper Backing
4. The 4" section is placed in front of the rib on base with the
tapered
end facing the back of the sleeve. The remaining
portion will be placed behind the rib again sloping toward
the rear of the sleeve. This helps induce a rearward
slope
on the unit.
5. Attach (1) 1 W' x 3/8" x 25" long seal in the center at the
top of the sleeve.
Remove the backing
paper and press
into position.
6. Attach (2) 1 W' x 3/8" x 14" seals to the left and right sides
of the sleeve.
7. Cut the 1 W' x 3/8" x 25" long seal to 14" long and attach it
to the vertical section of the rear grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way
back, remove 2nd screw from
front on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground wire to
the unit as shown in picture. Make sure that the toothed
washer is against the cabinet.
12. Slide the unit completely
to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
13. Seal & Frame the unit as described
on the last page of
these instructions.
4
Advertisement
