Advertisement
Wall Sleeve Brands:
#1 Emerson
15"Deep
Rear Louvers
I/
I Illl
I I lllllllll
Top View
1. Redirect the louvers at the back of the wall sleeve as shown
opposite.
The use of pliers is recommended.
2. Attach (1) 1 1/2"x 3/8" x 25" long seal in the center at the
top of the sleeve.
Remove the backing
paper and press
into position.
3. Attach (2) 1 Y2"x 3/8" x 14" seals to the left and right sides
of the sleeve.
4. Cut the 1 1/2"x 3/8" x 25" long seal to 14" long and attach
it to the vertical section of the rear grille as shown.
5. Attach (2) 4 1/2"x 3 1/2"x 1 1/2"centering/support
blocks
one on each side wall. Place in center of side wall with
the tapered end facing the opening.
6. Gently slide unit into sleeve.
7. Before sliding all-the-way
back, remove 2nd screw from
front on left side of unit.
8. Remove
the plastic washer from the screw.
9. Screw and attach the other end of the ground wire to
the unit as shown in picture. Make sure that the toothed
washer
is against the cabinet.
10. Slide the unit completely
to the rear to ensure a good
seal, making sure the ground wire does not become
tangled.
11. Seal & Frame the unit as described
on the last page of
these instructions.
3
Advertisement
