Advertisement
Wall Sleeve Brands:
#3 Fedders or Friedrich
16 ¾" Deep
Rear Louvers
J
II
IIIIII
I IIIIIIIII
Top View
1. Redirect the louvers at the back of the wall sleeve as shown
opposite.
The use of pliers is recommended.
2. Attach (2) 4 W'x 3 W' x 1 W' centering/support
blocks one on
each side wall. Place in center of side wall with the tapered
end facing the opening.
3. Cut (2) 17" Tapered
Spacer Blocks as shown below into three
17"
I
pieces.
I'-"
"_
i"ql
j
_
--
3J4,, I : Taperedspaoer ,,ook
I
E
Cut Here I
12-1/2"
_ 2-1/2
Protection Paper Backing
4. The 2 W' section
is placed
in front of the rib on base
with the
tapered
end facing the back of the sleeve.
Cut the remaining
portion
to 12 W' and place behind
the rib again
sloping
toward
the rear of the sleeve.
This helps
induce
a rearward
slope
on
the unit.
5. Attach
(1) 1 W' x 3/8" x 25" long seal in the center
at the
top of the sleeve.
Remove the backing
paper and press
into position.
6. Attach (2) 1 W' x 3/8" x 14" seals to the left and right sides
of the sleeve.
7. Cut the 1 W' x 3/8" x 25" long seal to 14" long and attach it
to the vertical section of the rear grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way
back, remove 2nd screw from front
on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
12. Slide the unit completely
to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
13. Seal & Frame the unit as described
on the last page of
these instructions.
5
Advertisement
