Lopi Freedom Fireplace Insert Owner's Manual page 32

32
Make sure the holes in the retainer line up with the holes on the shell then use a 5/16" nutdriver to
secure the shell with the two screws. Tighten until the door shell is snug against the retainer (do not
over-tighten).
5/16" Nutdriver
5. Attach the door handle
following the directions to
the right.
6. Replace the door on the
hinges and latch the door.
7. Attach the ashlip trim
following the directions
below.
© Travis Industries
Optional Equipment
1/16" Hex Wrench
Slide the ashlip trim into place then tighten the three
set screws on the bottom of the ashlip to secure.
NOTE: in rare cases the door retainer may not line up with
the door shell, preventing the door handle from lining up
correctly. To adjust the position horizontally, loosen the set
screws (see step 3) and adjust the door retainer position. To
adjust vertically, remove the retainer and adjust the clips on
the door shell (see step 2).
100-01162
9/16" Wrench
4041105