Dell PowerConnect M8024-k User Manual page 16

Stacking dell powerconnect 10g switches
Hide thumbs Also See for PowerConnect M8024-k:
Table of Contents

Advertisement

Stacking PowerConnect 10G Switches: M8024-k, 8024, 8024F
Note: The running-configuration doesn't need to be copied to the startup-configuration in order to
create the stack on the next reload. When the stacking commands above were added to the running-
configuration they were also added to the meta-data (see meta-data considerations above) and will be
utilized from that location upon reload. After a reload the running-configuration will continue to show
the stack members, though may not be reflected in the startup-configuration until a "copy running-
configuration startup-configuration" command is issued.
Stack Member units serial ports and management IP addresses are no longer accessible for managing
those devices. The Master's management ports are required to monitor and configure every port in
the stack.
Validation
After the entire stack reloads, it can be validated by entering the following commands on the Master
switch.
console#show switch chassis-mgmt
Management
Switch
Status
------ ------------ -------
1
Mgmt Switch
2
Stack Member
3
Stack Member
The command above displays the slots in the M1000e where each stack member resides. If using
multiple M1000e chassis, you may see multiples of the same slot name. For example, it may display all
three switches as being in slot B2, if each stack member resides in B2 in three different M1000e
chassis.
console#show switch
Management Standby
SW
Status
Status
--- ---------- --------- ----------- ----------- -------- -------
1
Mgmt Sw
2
Stack Mbr
Oper Stby PC8024F
3
Stack Mbr
The above command displays the model of each device in the stack and the firmware version.
console#show switch stack-ports
Unit
Interface
---- ---------------- ---------- ---------- ------------ ------------
1
0/17
1
0/18
1
0/19
1
0/20
1
1/1
Slot
A
B2
C2
Preconfig
Plugged-in
Model ID
Model ID
PC8024
PC8024
PC8024F
PC8024
PC8024
Configured
Running
Stack
Stack
Mode
Mode
Stack
Stack
Stack
Stack
Ethernet
Ethernet
Ethernet
Ethernet
Ethernet
Ethernet
Switch
Code
Status
Version
OK
4.2.0.3
OK
4.2.0.3
OK
4.2.0.3
Link
Link
Status
Speed (Gb/s)
Link Up
10
Link Up
10
Link Down
Unknown
Link Down
Unknown
Not Created
Unknown
14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect 8024Powerconnect 8024f

Table of Contents