Winding A Bobbin - Singer 4671 User Manual

WINDING A BOBBIN
Winding a bobbin is quick and easy when you follow the directions below Always wind the
bobbin before threading the machine.
* Push in indent (1) on hand wheel disc, This will stop the needle from moving.
This step is not necessary if your machine does not have hand wheel disc.
* Place spool of thread on spool pin.
* Slide spool cap (2) firmly over rim of spool to prevent thread tangling,
* Lead thread from spool and snap into thread guide post (3).
* Wind thread clockwise around front of bobbin winder tension disc (4).
* Pass thread end, from inside, through small hole in rim of bobbin.
. Place bobbin on spindle and push it to the right. On machines without hand wheel
disc, this will automatically stop needle from moving.
. Holding thread end, step on speed controller to run machine until desired amount
of thread is wound, (Winding stops automatically once bobbin is full.)
* Cut thread; push bobbin to the left and remove it from spindle.
. Trim thread end from top of bobbin
* Return hand wheel disc to sewing position by pressing on side opposite indent,
2
I
~~~~~~~i
I.
4
~ ~ ~ ~ ~ ~ ~ ~ ~~~~~~~------
7,~
~~~~~~~~~~~--
-----