Connecting The Machine/Running The Machine - Singer 4671 User Manual

CONNECTING THE MACHINE
The solid state system assures constant speed as you maintain the same pressure
on the controller when sewing through various fabric thicknesses
Unwind the air control hose from foot
operated speed controller
Always be sure air hose is not blocked
Pressing on the controller, you should
feel a slight air flow from the hose.
Plug this air hose onto the receptacle
above power cord, at the right end of the
Ja \' machine.
Then connect the electrical power cord
67
fplug to your electrical outlet.
NOTE: When not using the machine,
rewind air hose around speed controller
for storage, as shown
Do not operate machine without
material under the presser foot as this
may damage the feed and the foot
RUNNING THE MACHINE
The machine and the sewing light are turned on and off by the same power switch
1-
'---- (A)
r
SLIDE SWITCH (A)-
To turn on machine and sewing light,
m
l ii
|
_- r-q
slide power switch left to t1 position
To turn off machine and light, slide
power switch to right to 0 position
rri
I I
I4
l ROCKER SWITCH (B)-
To turn on machine and sewing light, press
power switch down at right side To turn off
machine and light, press power switch
down at left side,
_a To run the machine, press the speed
controller The harder you press, the fas-
ter the machine will sew
o stop the machine fromTi sewing.
remove pressure from speed controller
7