Using The Optional Sp01 Shock-Mount - Samson C01 Owner's Manual

Using the Optional SP01 Shock-Mount

Using the Optional SP01 "Spider" Shock-Mount
For additional isolation the C01 can be fit-
ted on the optional SP01 "Spider" shock
mount. Follow the steps below the to
install the SP01.
• First, screw the SP01 shock mount
onto your mic stand or boom arm. If
you're using a US 5/8" mic stand or
boom, remove the Euro adapter.
• Remove the C01 swivel mount by
rotating the threaded collar counter-
clockwise as shown in figure 1.
• Install the C01 into the SP01 by fitting
the microphone into the center of the
web, positioning the C01 onto the bot-
tom mounting plate.
• Secure the SP01 by reinstalling the
threaded collar, rotating clockwise
until tight. (Figure 2)
• Now, loosen the thumb screw to
adjust the angle of the microphone
and position the C01 to the desired
location. Once set, tighten the thumb-
screw to secure the microphone in
place.
Note: Be careful not to cross thread
or over tighten the threaded collar or
thumb screw.
1
2
THREADED
COLLAR
5
THREADED
COLLAR
SP01
SHOCK MOUNT
THUMB
SCREW