Belkin Wireless G Router User Manual page 96

Manually Configuring Network Settings
Restart the computer. When the computer restarts, your network
adapter(s) are now configured for use with the Router.
Set up the computer that is connected to the cable or DSL modem FIRST
using these steps. You can also use these steps to add computers to your
Router after the Router has been set up to connect to the Internet.
Manually Configuring Network Adapters in Mac OS up to 9.x
In order for your computer to properly communicate with your Router, you
will need to change your Mac computer's TCP/IP settings to DHCP.
1.
Pull down the Apple menu. Select "Control Panels" and
select "TCP/IP".
2.
You will see the TCP/IP control panel. Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu
(1)
(2)
3.
Next to "Configure"
need to be set up for a static IP connection type. Write the address
information in the table below. You will need to enter this information
into the Router.
4.
If not already set, at "Configure:", choose "Using DHCP
Server". This will tell the computer to obtain an IP address
from the Router.
(2)
, if "Manually" is selected, your Router will
92 92
(1)
.