Canon imageRUNNER 2320 User Manual page 106

Output tray full/Remove paper
Cause
Remedy
Over page limit/Press OK key
Cause
Remedy
4
Paper jam
Cause 1
Remedy
Cause 2
Remedy
Platen glass dirty/Clean platen glass
Cause
Remedy
Restart the machine./If problem persists,/call service rep.
Cause
Remedy
Set doc. on glass
Cause
Remedy
4-8
List of Error Messages
The output tray is full of paper.
Remove the prints from the output trays.
The machine is set to restrict printing, and the set page limit for printing has
been reached.
From the Dept. ID Management (Department ID Management) menu in the
System Settings menu, open the Limit Settings menu and change the maximum
number of pages that can be printed.
An original jam or paper jam has occurred.
Remove the jammed paper from the machine. (See "Clearing Paper Jams,"
on p. 4-2.)
A cover has been opened during printing.
Open the cover again and check if there is any jammed paper. Clear the
jammed paper, if any, and close the cover. The message disappears, and
printing resumes.
The feeder's scanning area is dirty.
Clean the feeder's scanning area. (See Chapter 6, "Routine Maintenance," in
the Reference Guide.)
An error has occurred.
Contact your local authorized Canon dealer. (See "Contacting Your Local
Authorized Canon Dealer," on p. 4-11.)
The original has been placed in the feeder and a mode that cannot be used with
the feeder, such as the 2-Page Separation mode, has been selected.
Place the original on the platen glass.