Attaching; Initial System Start-Up; Adjusting Volume; Setting Time - Alpine CDE-185BT Owner's Manual

Attaching

Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first time,
after changing the car battery, etc.
RESET switch

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Setting Time

1
Press and hold AUDIOSETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select GENERAL, and then
press ENTER.
3
Turn the Rotary encoder to select the CLOCK ADJ mode,
and then press ENTER.
The time indication will blink.
4
Turn the Rotary encoder to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press ENTER.
6
Turn the Rotary encoder to adjust the minutes while the
time indication is blinking.
7
Press and hold AUDIOSETUP for at least 2 seconds to
return to normal mode.
10
-EN
Notes
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold ENTER for at least 2 seconds after
setting the "hour". Minutes will reset to "00". If the display shows over
"30" minutes when you do this, the time will advance one hour.
• Even when AUTO CLOCK is set to ON (refer to "Setting the Time to
automatically be adjusted" on page 23), the time can be adjusted
manually. At the same time, if there is an adjustment request from RDS,
the time will be adjusted automatically by RDS data.
• Pressing t will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote control
sensor.
Remote control sensor
Connectable to Remote Control Interface Box
With an optional Alpine Steering Wheel Remote Control Interface
Box (not included), this unit is controllable from the vehicles
steering wheel controls. For details, contact your Alpine dealer.