Pro-Form CrossWalk GTS User Manual page 7

6. Place the Console Base (46) on the Right Handrail (103)
and the Left Handrail (not shown). Attach the Console
Base with four 1 1/4" Screws (81) (only two Screws are
shown). Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated
plastic ties on the Console Base (46). Next, insert the
Wire Harness up through the opening beside the Console
Cover (110). Make sure that the Console Cover is se-
curely attached to the Console Base.
Refer to the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas-
tic tie on top of the Console Base.
7. Hold the Console (10) near the Console Base (46).
the Right Handrail (103) to discharge any static. Find
the 3-wire connector on the end of the Wire Harness (21).
Insert the connector into the red socket beneath the console.
The connector should slide easily into the socket and
snap into place. If the connector does not slide easily and
snap into place, turn the connector and then insert it. Insert
the 5-wire connector into the black socket beneath the con-
sole in the same way. Make sure that the connectors and
wires appear as shown in the inset drawing.
Insert the excess Wire Harness down through the opening in
the Console Base (see the inset drawing in step 6 above).
Securely tighten the plastic tie on top of the Console
Base to prevent the Wire Harness from slipping. Then,
cut off the end of the plastic tie.
Refer to drawing 7a. Press the Book Rack (101) onto the
Console Base (46) in the location shown.
Set the Console (10) on the Console Base (46). Insert the ex-
cess Wire Harness (21) into the large hole in the side of the
Right Handrail (103). Securely tighten the plastic ties on
the bottom of the Console Base to prevent the Wire
Harness from slipping. Cut off the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with two
1/2" Silver Screws (47) and four 3/4" Screws (13). Start all
six Screws before tightening them; do not overtighten
the Screws.
8. Attach the Storage Latch (14) to the left Handrail (102)
with two 3/4" Screws (13).
tighten the Screws.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between
the Handrails (102, 103 [not shown]). Firmly tighten all
of the bolts and screws used in assembly steps 3, 4,
5, and 6. Then, lower the frame to the floor.
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
Touch
Be careful not to over-
6
46
Ties
103
81
7
10
Ties
103
7a
46
8
102
14
7
21
110
21
21
21
3-Wire
46
13
13
47
101
13
Tie
46
5-Wire