3. Insert a Plastic Shim (104) into each side of the post on
the right side of the Base (11). Next, orient the Right
Handrail (103) as shown, and insert it into the Base.
careful to avoid pinching the Handrail Wire Harness
(21). Note: If necessary, tap the Right Handrail with a
rubber mallet until it is fully seated in the Base. If the
Right Handrail cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Handrail.
Attach the Right Handrail (103) to the Base (11) with
three 1" Bolts (8) and three 1/4" Star Washers (9). Do
not tighten the Bolts yet.
Assemble the Left Handrail (not shown) in the same
way. Note: There is not a wire in the Left Handrail.
4. Hold the Crossbar (1) between the Handrails (102, 103).
Attach the Crossbar with two Crossbar Screws (53). Do
not tighten the Crossbar Screws yet.
Attach the ring on the end of the ground wire to the small
hole in the side of the Right Handrail (103) with a Silver
Ground Screw (109).
5. Hold the Left Upper Body Arm (89) near the Left Handrail
(102) as shown. Make sure that the Resistance Knob
(98) is on the indicated side. Attach the Left Upper Body
Arm to the Left Handrail with two 3" Bolts (78), two
Washers (39), and two 3/8" Star Washers (29) as shown.
Attach the Right Upper Body Arm (94) to the Right
Handrail (103) as described above.
pinch the wires in the Right Handrail.
Be
Be careful not to
6
3
103
9
8
4
1
53
102
Ground
Wire
103
5
89
102
29
39
98
78
78
21
9
104
8
11
109
53
94
103
39
29