GE GTUP270GM3WW Installation Instructions Manual page 9

Installation instructions
DO
ELBOW HIGHLY
RECOMMENDED
USE
DO NOT _
EXCESSIVE
DON'T
EXHAUST
LENGTH
[-_ 24" MODELS ONLY:
DRYER EXHAUST TO RIGHT, LEFTOR
BOTTOM CABINET
WARNING - BEFORE P ERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE APPLIANCE FROM
ITS ELECTRICAL SUPPLY. PROTECT
YOUR HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING INSIDE THE
CABINET. BE SURE TO WEAR GLOVES
For downward venting, rotate elbow
sections so that elbow points downward
L
REMOVE
DESIRED
KNOCKOUT
(ONLY 1)
0
!
FLO0
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
, For side ducting, remove the knockout (ONLY 1). Rotate
elbow sections so that the opening points to the side.
Preassemble 4" elbow with 4" duct. Use only 4" UL
approved rigid metal for ducting inside the dryer.
, Insert duct assembly through the side opening and
connect to the internal elbow.
CAUTION:
Be sure not to pull or damage the
electrical wires inside the dryer when inserting the duct.
4" UL approved rigid metal
DUCT
TAPE
Apply duct tape as shown on the joint between the dryer
internal duct and the straight duct pipe.
kCAUTION:
Internal duct joints must be
R ecured with tape, otherwise
they may separate and cause
a safety hazard.
27" MODELS ONLY:
DRYER EXHAUST TO RIGHT, LEFT OR
BOTTOM CABINET
,_WARNING
- BEFOREPERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE APPLIANCE FROM
ITS ELECTRICAL SUPPLY. PROTECT
YOUR HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING INSIDE THE
CABINET. BE SURE TO WEAR GLOVES
For downward ventinc
sections so that elbow
rotate elbow
_oints downward
9