Honeywell TrueSTEAM HM506 Installation Manual page 5

Hide thumbs Also See for TrueSTEAM HM506:
Table of Contents

Advertisement

Available languages

Available languages

Setting Homeowner
Expectations
Make sure the homeowners know what to expect from their TrueSTEAM humidifier, Discuss the following points
with the homeowners and answer any questions they have,
,, Achieving Humidity
Setpoint.
It may take up to a week of continuous operation to achieve the humidity
setpoint. This depends on such factors as weather, size of home, furnishings in the home, and insulation.
,,
Plastic or Rubber Odor. At startup, it is normal to smell a slight plastic odor in the home. If the remote hose
is used, there may be a slight rubber odor. These odors will go away within a few days.
Ideal Humidity.
35% relative humidity in typical winter weather is considered
ideal by industry experts.
Homeowners can adjust to their own comfort or until there is condensation
on the windows. Lower the
setpoint if condensation
appears.
,,
Unit Hot Humidifying.
If TrueSTEAM is not running but the humidity is below the setpoint, the humidity
control may have a frost protection setting. TrueSTEAM will not humidify while in a drain cycle mode.
Setpoint
Not Reached. If humidity doesn't reach the setpoint, TrueSTEAM may be undersized for the home.
This can be due to factors such as insulation, windows, and arid climate. Also, the outdoor temperature
may
be too low to maintain the humidity level. Wait for the outdoor temperature to warm closer to 20°F (-6°C). If the
desired humidity is still not reached, then a larger capacity TrueSTEAM may be needed.
Home Ventilation.
Excessive ventilation sends moist air outside and replaces it with dry air. This can make it
hard to maintain the humidity setpoint. If installing a ventilator, use a solution that retains moisture. An Energy
Recovery Ventilator (ERV) is recommended.
Cleaning Required Light. If the Cleaning Required light is on, clean TrueSTEAM using the steps found in
the "Routine Maintenance" section on page 24, or in the Homeowner's Operating Manual. TrueSTEAM will
continue to run normally while this light is on.
Hard Water. The home's water hardness determines how often TrueSTEAM must be cleaned. A water
hardness test kit is provided with your TrueSTEAM. It will help you determine the cleaning interval and filter
requirements for your TrueSTEAM.
Energy Consumption.
There may be a slight increase in overall energy consumption when operating
any humidifier. However, TrueSTEAM will make the home feel warmer. This allows the homeowner to lower
the temperature setting on the thermostat. Every degree lower on the thermostat can save up to 3% on
heating costs.
TrueSTEAM Humidification
System
69-2285EF--01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Truesteam hm509Truesteam hm512

Table of Contents