Bosch HGS7022UC/01 Installation Manual page 2

Important Safety Instructions
Table of Contents
Important Safety Instructions ........................................................................................ 1
Preparation .................................................................................................................. 3
Installation ................................................................................................................... 4
Final Steps ................................................................................................................... 5
Please read all instructions before using this appliance.
PARTS PROVIDED:
Anti-Tip Bracket
TOOLS AND PARTS NEEDED:
* Standard Measuring Tape
* Phillips Head Screwdriver
,, 1-1/4" Wrench
Pencil
T-20 Torx Screwdriver
3/8" Nut Driver
Screws (2) and Anchors (2) for Anti-tip Bracket
(Style will vary depending on mounting surface)
Pipe Wrench (2)
Teflon® Tape* or Pipe Joint Compound
(Appropriate for use with LP gas and Natural gas)
Channel Lock Pliers
Gas Leak Test Solution
Level
Drill and Drill Bit
Gas Supply Line (Flexible Metal Appliance
Connector or Rigid Pipe)
Gas Shut Off Valve (If not already present)
Gloves and Safety Goggles
* Teflon is a registered trademark of DuPont
_kWARNING: :If the information in
this manual is not followed exactly,
a fire or explosion may result
causing property damage, personal
injury or death.
® Do not store or use combustible
materials, gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
® Do not touch any electrical switch.
® Do not use any phone in your
building.
® Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
® If you cannot reach your gas
supplier, call the fire department.
Installation and service must be
performed by a qualified installer,
authorized service agency or the gas
supplier.
,. Remove all tape and packaging before using
the range, Destroy the carton and plastic bags
after unpacking the range. Never allow children to
play with packaging material.
,. Be sure your appliance is properly installed
and grounded by a qualified technician in
accordance with the National Electrical Code ANSI/
NFPA No. 7 latest edition and local electrical code
requirements.
Important: Local codes vary. installation,
electrical connections and grounding must comply
with all applicable codes.
• Install only per installation instructions
included in the literature package for this
range,
Ask your dealer to recommend a qualified
technician and an authorized repair service,
,. Know how to disconnect the power to the
range at the circuit breaker or fuse box in and the
gas supply at the shutoff in case of an emergency.
,. Do not repair or replace any part of the
appliance unless specifically recommended
in the manuals, All other servicing should be
done by a qualified technician. This may reduce
the risk of personal injury and damage to the
range.
• When testing the supply piping system at
test pressures in excess of 1/2 psig (3,5
kPa), the appliance and its indiviual shut=off
valve must be disconnected from the gas
piping system,
,. When testing the supply piping system at
test pressures equal to or less than 1/2 psig
(3,5 kPa), the appliance must be isolated
from the gas supply piping system by
closing its individual manual shut=off valve,
,. Never modify or alter the construction of a
range by removing leveling legs, panels, wire
covers, anti-tip brackets/screws, or any other part
of the product.
• Do not lift door by door handle, Remove the
door for easier handling and installation. See
Section 'Removing Oven Door' in Use and Care
manual.
1! I
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
m
English * 1