Amana AGG222VDB0 Installation Instructions Manual page 15

3. Removethe LPgasorifice s puds u sing a7 mm combination
wrench.
4. Install Naturalgas orifice s puds u sing a7 mmcombination
wrench.
o \
G ' A .......................... .......................
A. Spud
B. Holder
NOTE: This range is equipped with 2 standard burners and
2 super burners. Spud size/location remain the same.
To Convert Oven Burner
1.
2.
Open oven door and remove oven racks, oven tray, flame
spreader and set aside.
Lift oven burner. The orifice spud is behind the oven burner
air shutter.
A
A. Air shutter
3. Locate natural gas orifice spud stamped "51" in literature
package supplied with range.
4. Use a %" combination wrench and remove the LP gas
orifice spud.
5. Install the number "51" Natural gas spud.
IMPORTANT: Do not over tighten.
6. Place LP gas oven burner spud in plastic parts bag along
with LP gas cooktop burner spuds for future use and keep
with bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
5. Place the LP gas orifice spuds in the plastic parts bag for
future use and keep with bag containing literature.
6. Reinstall burners, burner caps and burner grates.
1. Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2. Turn the manual shutoff valve in the gas supply line to the
open position.
3. Refer to the "Check Operation" section for proper burner
ignition, operation, and burner flame adjustments.
iMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to _" (0.64 cm to 1.3 cm long). The outer cone
is not as distinct as the inner cone. Natural gas flames do not
have yellow tips.
4. Close the broiler door and press the "OFF" pad.
5. Refer to the "Complete Installation" section to complete this
procedure.
15