Garrett MAGNASCANNER PD 6500 Owner's Manual page 18

5.11. ALTER SUPERVISOR ADJUSTMENTS
The Supervisor Adjustments code (referred to as CODE1) is factory preset to 1234. To
change it:
1. Press the + touchpad.
2. Enter a new four-digit code.
3. When the LCD prompts, REPEAT CODE, re-enter the new four-digit code. The mes-
sage, CODE ENTERED OK, should appear. (If the message, INVALID ENTRY,
appears, repeat steps 2 and 3.)
Press ACCESS for the next adjustment or OPERATE to resume normal operation.
5.12. ALTER INSTALLATION ADJUSTMENTS
The Installation Adjustments code (referred to as CODE2) is factory preset to 5678. To
change it:
1. Press the + touchpad.
2. Enter a new four-digit code.
3. When the LCD prompts, REPEAT CODE, re-enter the new four-digit code. The mes-
sage, CODE ENTERED OK, should appear. (If the message, INVALID ENTRY,
appears, repeat steps 2 and 3.)
NOTE: To revert to factory settings:
1. Open the main cover of the detection unit.
2. Remove the three screws attached to the controller module cover.
3. With power turned on and the unit in Operate mode, press and hold the ACCESS
CODE RESET button (on the left side of the circuit board) for five seconds. (See
Figure 10-1.)
4. The codes for the Supervisor Adjustments and Installation Adjustments modes
should revert to 1234 and 5678 respectively.
Special Note
For added security, both access codes should be changed from the factory settings and
revealed only to those who use them. Record the new access codes on the access settings
card that accompanies this manual. Codes should be changed periodically, especially when
changes in personnel occur.
Press OPERATE to exit the Installation Adjustments mode and resume normal
operation. (If ACCESS is pressed, the Installation Adjustments cycle starts over,
beginning with the prompt, RX BALANCE.)
©2000 GARRETT METAL DETECTORS, INC.
6/19/00
MAGNASCANNER PD 6500
OWNER'S MANUAL
16
(+ TO ALTER CODE1)
(+ TO ALTER CODE2)
PN 1531100