Nvidia nForce 570 SLI User Manual page 16

Introduction
Connectors
CFP
8
CIR
CSPK
SATA1
9
SATA6
SATA7
10
SATA8
(Optional)
11
LEDION
12 LPT1
13 THM-ST
(Optional)
14 CP80P
15 EZ-Button
12
Figure
1
GND B+ B- A- A+ GND
GND
1
GND B+ B- A- A+
GND
GND
Descriptions
CFP: Case Front Panel Connector
HD_LED
This LED indicates hard drive activity.
PWR_LED
Connects to the power indicator on the PC case.
RST
Connects to the RESET switch on the PC case.
PW_ON
Connects to the Power button on the PC case, to turn on
the system. To turn off the system, press the power
button for 4 seconds.
CIR: IR connector
For connection to an IrDA receiver unit.
CSPK: Speaker
Connects to the case's speaker for PC beeps.
SATA1 ~ SATA6: Six S-ATA II Connectors
These connectors enable you to connect Serial ATA HDDs or
optical drives type.
SATA7 ~ SATA8: Two S-ATA II Connectors
These connectors enable you to connect Serial ATA HDDs or
optical drives type with e-SATA.
LEDION:
Onboard LED indicators to show the power status of CPU,
Chipset and DRAM. You know immediately where to look if the
system fails to start.
LPT1: Parallel Port (printer) Connector
The parallel port can be used for printers and other parallel
device.
Thermo Stick:
Flexible thermometer to let you measure any temperature by
software. Ideal for monitoring VGA card, chipset or even disk
drives temperatures.
CP80P: Post Port Debug LED
Provides two-digit POST code to show why the system fail to
boot. Allows quick and easy optimization.
The LED will display the CPU temperature when you run the
bundled Thunder Probe software.
EZ-Button — RESET, PW-ON:
These onboard buttons lets you turn on/off the system
easily, it is especially handy for debugging or testing the
system.