Download Print this page

Jenn-Air JJW9330DDB Installation Instructions Manual page 2

27" (68.6 cm) and 30" (76.2 cm) electric single and double built-in oven
Hide thumbs Also See for JJW9330DDB:

Advertisement

Available languages

Available languages

INSTALLATIONREQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Product Dimensions - Single Oven
27" (68.6 cm) and 30" (76.2 cm) Ovens
Tools needed
Phillips screwdriver
Measuring tape
Hand or electric drill (for wall cabinet installations)
11¼"(25 mm) drill bit (for wall cabinet installations)
Level
Parts needed
UL listed or CSA approved conduit connector
UL listed wire connectors
Parts supplied
# 8-14 x 3A,,screws - single oven (4), double oven (8)
Bottom trim (supplied on some models)
Two # 8-18 x 3/8"screws - bottom trim (supplied on some
models)
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended
that all electrical connections be made by a
licensed, qualified electrical installer.
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
Grounded electrical supply is required. See "Electrical
Requirements" section.
Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the oven is
installed in a wall cabinet. A 1W' (3.4 cm) minimum diameter
hole should have been drilled in the right rear or left rear
corner of the support surface to pass the appliance cable
through to the junction box.
NOTE: For undercounter
installation, it is recommended
that
the junction box be located in the adjacent right or left
cabinet. If you are installing the junction box on rear wall
behind oven, the junction box must be recessed and located
in the upper or lower right or left corner of the cabinet;
otherwise, the oven will not fit into the cabinet opening.
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a
single oven weight of 142 Ibs (64.4 kg) or a double oven
weight of 250 Ibs (113.2 kg).
Undercounter
Installation (with cooktop installed above):
Ovens approved for this type of installation have an approval label
located on the top of the oven. Refer to undercounter
installation
instructions for cutout dimensions and approved oven cooktop
combinations
(separate sheet).
E
_CJ
B
27" (68.6
cm)
models
A. 25%" (64.5 cm) max. recessed
width
B. 28¼" (71.8 cm) max. overall
height
C. 263/4'' (67.9 cm) overall width
D. 23Y2" (59.7 cm) max. recessed
depth
E. 271/2'' (69.9 cm) recessed
height
30"
(76.2 cm)
models
A. 28¼" (71.8 cm) max. recessed
width
B. 28¼" (71.8 cm) max. overall
height
C. 293/4'' (75.6 cm) overall width
D. 23Y2" (59. 7 cm) max. recessed
depth
E. 271/2'' (69.9 cm) recessed
height
Cabinet Dimensions - Single Oven
27" (68.6 cm) and 30" (76.2 cm) Single Oven Undercounter
(without cooktop installed above)
E
.,_
A
B
C
A. 27" (68.6 cm) min. cabinet width on 27" (68.6 cm) models
30" (76.2 cm) min. cabinet width on 30" (76.2 cm) models
B. 11/2 '' (3.8 cm) min. top of cutout to underside of countertop
C. 5%" (13.0 cm) bottom of cutout to floor
D. 281/2'' (72.4 cm) cutout width on 30" (76.2 cm) models
E. 277/8 '' (70.8 cm) min. cutout height
2

Advertisement

loading