Corded Buttonhole; Step By Step Buttonhole; Buttonhole Balance - Husqvarna Viking Designer I Usb User Manual

Corded Buttonhole

brics)
• Loop a piece of heavy thread or perle cotton
over the fi nger at the back of the Sensor But-
tonhole Foot or the C presser foot
• Stitch a buttonhole. Do not hold back the
cord. The satin buttonhole columns will stitch
over the cord.
• Stop sewing before the last end of the but-
tonhole is sewn and lift the cord off the fi nger
and pull out the slack.
• Cross the cord in front of the needle and
stitch the end of the buttonhole over the cord.
• Thread cord ends into a large needle, pull to
the wrong side and knot ends before cutting
excess.

Step by step buttonhole

• Select buttonhole. and snap on Presser Foot C
• Begin sewing buttonhole, the machine will
sew the left column in reverse. The button-
hole foot has guide lines to determine the
buttonhole length. Use the markings on the
left toe of the Buttonhole Foot to position the
garment edge. When the buttonhole is the
desired length, touch
bar tack the end and stitch the right side.
• Touch to bar tack and tie off. Keep the
foot control depressed until the machine ties
off and stops sewing. The Thread Cutter cuts
the threads automatically when the button-
hole is completed.

Buttonhole balance

To balance the stitch dens ity of the right but-
tonhole column to the left, when a buttonhole is
selected, touch
buttonhole.
Note: Only the right side stitch column will be
adjusted. Balance it to match the left stitch column.
will make the stitches in the right column
closer together (more dense).
stitches further apart (less dense).
The set ting will be re tai ned until the
USB
Designer I
is turned off.
To change the stitch density of both columns,
see Buttonhole Density.
52
Utility/Garment Sewing
(Stretch fa-
. The machine will
. The balance icon is now a
will make the
5/8" (15 mm)