Weider Pro 9510 User Manual page 6

2. Slide the Front Upright (42) onto the 5/16" x
2 1/2" Carriage Bolts (1) in the Base (4). Hand
tighten a 5/16" Nylon Locknut (3) onto each
Carriage Bolt. Do not tighten the Nylon
Locknuts yet.
Press a 1" Square Inner Cap (65) into the
Front Upright (42).
Press 1" Round Inner Cap (49) into each end
of the Foot Rest (83). Attach the Foot Rest to
the Rear Upright (56) with a 5/16" x 2 3/4" Bolt
(11), two 5/16" Flat Washers (8), a 1/2" x 1/2"
Bushing (87), and a 5/16" Nylon Locknut (3).
3. Press a 2" Square Inner Cap (27) into the indi-
cated end of the Top Frame (55). Press a
1 3/4" Square Inner Cap (44) into each end of
the crossbar on the Top Frame. Press two 1"
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16"
x 2 3/4" Bolts (11), four 5/16" Flat Washers (8),
and four 5/16" Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1
through 3.
4. Set two Weight Bumpers (19) onto the indicat-
ed bracket on the Base (4) as shown.
Stack eight Weights (25) onto the Weight
Bumpers (19). Be sure that the pin grooves
are all on the indicated side and that the
"WEIDER" logos are on top.
2
56
8
49
87
11
8
11
3
8
27
55
56
44
3
WEIDER
4
25
6
42
3
83
65
3
49
4
1
11
8
49
44
Crossbar
42
3
Pin
Groove
19
4