Weider Pro 9510 User Manual page 15

33. Press 3/4" Round Inner Caps (34) into the
ends of both 12 1/2" Pad Tubes (28).
Insert one 12 1/2" Pad Tube (28) into the
Seat Frame (36). Slide a 5 1/2" Pad (30) onto
each end of the Pad Tube.
Insert the other 12 1/2" Pad Tube (28) into the
Leg Lever (29). Slide a 5 1/2" Pad (30) onto
each end of the Pad Tube.
See the left inset drawing. Insert the head of
the 5/16" x 1 1/4" Carriage Bolt (90) into the
keyhole in the Leg Lever (29). Be sure that
the shoulder of the Carriage Bolt is firmly
seated in the square part of the keyhole.
See the right inset drawing. Orient the Short
Cable (35) and the Curl Bar (86) as shown.
Tighten the indicated 5/16" Nylon Locknut (3).
Do not overtighten the Nylon Locknut. This
is the storage position for the Curl Bar.
34. Attach the Curl Pad (82) to the Curl Frame
(84) with four 1/4" x 1/2" Screws (18).
Insert a 1 1/2" Square Inner Cap (32) into
each end of the Curl Frame (84). Note:
These Square Inner Caps may come pre-
assembled.
35. Attach the Curl Frame (84) to the Seat Frame
(36) by inserting the pin on the Curl Frame
into the upper hole in the Seat Frame. Secure
the Curl Frame with the Curl Knob (85).
33
36
30
29
29
Keyhole
90
34
32
18
18
32
35
15
30
34
28
34
3
82
18
84
85
84
36
86
35