Install Indoor Unit - Haier 10571570 Operation Manual

Two by one room air conditioner

Hide thumbs

Table of Contents

Installation procedure

The indoor side drain hose and the parts connected with indoor unit should be

thermal insulated. Improper thermal insulation may cause dew-forming

phenomenon.

The drain hose should be as short as possible. The droop slant degree at least

should be 1/100 to avoid forming of gas bag.

If cannot make the drain hose have an enough slant degree, a drainage

enhancing hose should be equipped.

In order not to let the drain hose bend, a 1~1.5m distance should be kept

between suspending frame.

Droop slant degree over

1/100 Support frame

Thermal insulation material

(customer self-provided)

Thermal insulation treatment:

Use thermal insulation material, as figure shown, to bind

the hose and the hose buckle to the bottom of the indoor

unit without any gaps.

Hose

The hose can be used to adjust the radius and angle of stiff PVC pipe.

*Directly stretch the hose to perform work, do not make it deform.

*The soft end of the hose must be fixed by the hose buckle.

Please use the hose in the level part.

Radius adjustment

(Max 20mm)

The installation height of the drainage enhancing pipe should be less than 530mm.

The drainage enhancing pipe should be vertical to the unit and no more than 300mm away

from the unit.

Within 300mm

Drain hose

(accessory)

Wire clamp (accessory)

Instruction)

*The slant of the accessory drain hose should be within 75mm to make the drain faucet not

bear too much excessive external force.

If many drain hoses join together, please install according to the following procedure.

The specification of the chosen joined drain hoses should be applicable to the operation capacity of the unit.

1m*1.5m

***

45* bend

Hoisting foot

1-1.5m

Drainage enhancing pipe

S-shaped bend

Accessorial thermal

insulation material Thermal insulation material

(Max)

Drain hose

(accessory)

T-joint joined drain hose