Haier 10571570 Operation Manual page 35

Installation procedure
(3)The circuit of the decorative panel
Connect the wire end of the louver motor installed on the decorative panel
6
(referring to Figure 7).
Side of indoor unit
3.Installation of air inlet grille and corner cover
(1)Install the air inlet grille
*
The reversed procedure to the "the preparation of decorative panel" part.
*
(2)Install the corner cover on the corner
**As Figure 8 shown, tie the rope of the corner cover on the cleat of the decorative
1
panel.
* Install the corner cover on the decorative panel (referring to Figure 9).
2
When installing the air inlet grille, be careful not
to wrap the wire of the louver motor.
Cleat
Figure 8
Install the decorative panel
Figure 7
<The indication diagram of circuit>
(different from the actual condition)
Slide the 5 buckles to install the
corner cover and make it meet with
the holes in the decorative panel
Figure 9
*****
33