Table of Contents
Advertisement
2 Installation
Make sure that all devices are powered off before starting installation.
2.1
Connect the Power
1 Connect the power adapter to the DC In jack of your Wireless Gateway.
2 Plug the power adapter to a wall outlet or a power strip.
▪ Use only the supplied power adapter. Using other power adapters may cause damage to the
device.
▪ Connect all devices to your Wireless Gateway before connecting the power adapter to a wall
outlet.
2.2
Connect Wired Devices
When setting up the Wireless Gateway for the first time, connect the host computer via Ethernet
connection.
1 Connect one end of the RJ-45 cable to one of the Ethernet (1, 2, 3, 4) ports of your Wireless
Gateway.
2 Connect the other end of the RJ-45 cable to the Ethernet port of the computer.
3 Repeat the above steps to connect other computers to the Wireless Gateway via Ethernet
connection.
4 To connect more than four computers, use a hub or switch. Connect one end of an RJ-45 cable to the
hub or switch and the other end to the computer.
Copyright © 2012 Technicolor. All rights reserved.
DMS-CTC-20120508-0000 v1.0.
Installation Diagram
SETUP & USER GUIDE
7
Hide quick links:
Advertisement
Table of Contents
