Table of Contents
Advertisement
Installation
Mounting the Camera (Continued)
Mounting the Camera Using the Conduit Hole at the Bottom of the
Base
Conduit hole: G3/4-14 UNC (TK-C2301WPRU), M25 (TK-C2301WPRE)
1 Remove the dome cover and inner dome (A page 23)
2 Remove the camera unit from the base and mount the fall
prevention wire to the camera unit
① Loosen the camera unit fastening screw (2 locations) with a
screwdriver.
② Press the catch (2 locations) inwards and remove the camera from
the base.
③ Remove the fall prevention wire fastening screw on the base to
mount the fall prevention wire. (The fall prevention wire is not
provided.)
.
3 Wind the sealing tape
Wind the sealing tape around the pipe junction (where the conduit hole
thread lines with the pipe screw hole) two or more times.
E-30
2
Catches (x2)
Camera unit
Base
1
Advertisement
Table of Contents
