Table of Contents
Advertisement
Introduction
Operating Precautions (Continued)
When the white balance of this camera is set to "ATW-N" or "ATW-W"
and depending on the conditions of the object, the color tone may
differ slightly from the actual color due to the principle of the
automatic tracking white balance circuit. This is not a malfunction.
When this camera is used under high temperatures, vertical stripes
may appear on the screen. This is a characteristic of the CCD and
not a malfunction.
When this camera is moved from a cold to warm place, condensation
may occur and the camera may not work. In this case, leave the
camera under room temperature for about one hour before turning on
the power.
When the power supply voltage is momentarily disrupted or drops
due to lightning, turning on the air-conditioner or the like, image
distortion or noise may occur.
When the power supply voltage of the camera drops, the input
protection circuit inside the camera operates, and the camera may be
turned off. Make use of a voltage rating within ±10 % for the camera's
power supply voltage.
This unit enlarges the rotation angle to support wide range set up.
When the zoom of the lens is set to WIDE end and the tilt angle is set
around ±80°, a part of this camera appears in the image depending
on the rotation angle. In this case, adjust the image angle if
necessary. (A page 35)
To prevent fogging resulting from temperature changes, be sure to
insert the silica gel at the location specified. (A page 26)
The 3D noise reduction function of this camera may result in
afterimage of a moving subject. Afterimage is more likely to occur
when using the camera with [DNR LEVEL] set to "HIGH". This is not
a malfunction.
E-14
Advertisement
Table of Contents
