Python 502 Owner's Manual page 21

To enter or exit Valet Mode using the remote control:
1. Open any vehicle door.
2. Press
3. Press
4. Press
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
➜
This feature (if programmed On) stops the alarm from arming or
activating any outputs that are programmed to activate when the
alarm is armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1. After parking turn the ignition off.
2. Turn the ignition On for more than 1-second and less than
3-seconds and then turn Off.
3. The siren will chirp once to indicate one-time bypass has
been activated.
16
.
or
.
again.
© 2006 directed electronics