System Adjust - Oki C9800 Series Service & Troubleshooting Manual

System Adjust

Item
Power Save Time
Clearable Warning
Auto Continue
Manual Timeout
Wait Timeout
Low Toner
Jam Recovery
Print Position Adjust
Darkness Cyan, Magenta,
Yellow, Black
Cyan Magenta Yellow
Reg Fine Adjust
Paper Black Setting
Paper Color Setting
Transparency Black Setting
Transparency Color Setting
Description (Printer Defaults are indicated in Blue)
Sets the period after which power save mode starts. 5 min, 15 min, 30 min,
240 min
When Online is selected, you must manually clear the warning by pressing the Online
button. Change to Job if you wish the message to automatically clear when a new print
job is received. Online
Sets whether the printer is automatically recovered when Memory Overflow or Tray
Request occurs. ON or OFF
If paper is not fed within this time in manual feed, the job is cancelled. OFF, 30 sec,
sec.
Sets the time period between stopping receipt of job data and forced print. For PS,
printing is not carried out and the job is cancelled. Range is off, 5 sec. to 300 sec.
default is 40 sec.
Sets the printing operation when insufficient toner is detected. Continue: the printer
can continue printing while remaining online. Stop: the printer stops printing and goes
offline.
ON: continues printing the job, including any jammed pages, once the jam has been
cleared. OFF: Cancels a job including the page currently jammed.
X Adjust - Adjusts the position of the whole printing image (0.25 mm at a time)
Range is -2.00 to +2.00 mm (horizontally). Default is
Y Adjust - Adjusts the position of the whole printing image (0.25 mm at a time)
Range is -2.00 to +2.00 mm (Vertically). Default is
Duplex X Adjust - During the flip-side printing of duplex printing, adjusts the position of
the whole printing image (0.25 mm at a time. Range is -2.00 to +2.00 mm
(horizontally). Default is
Duplex Y Adjust - During the flip-side printing of duplex printing, adjusts the position of
the whole printing image (0.25 mm at a time. Range is -2.00 to +2.00 mm (Vertically).
Default is 0.00mm.
Adjusts the engine density for Cyan, Magenta, Yellow, Black. Darkest value is +3,
Lightest value is -4. Default is
Makes fine adjustment to image registration against Black in the horizontal direction.
Adjust. is for Cyan, Magenta, Yellow. Range is -3 to +3. Default is
Used for micro adjustment when very visible faded print results or light specks (or
streaks) result when printing in Plain Paper/Black setting. Range is -2 to +2. Decrease
the value if light specks (or streaks) or snow flake like printing results in high density
print areas. Default is 0.
Used for micro adjustment when very visible faded print results or light specks (or
streaks) result when printing in Plain Paper/Color setting. The range is -2 to
+2.Decrease the value if light specks (or streaks) or snow flake like printing results in
high density print areas. Default is
As for Paper Black Setting above. The range is -2 to +2. Default is
As for Paper Color Setting above. The range is -2 to +2. Default is
or Job
0.00mm.
0.
0.
60 min,
60
0.00mm.
0.00mm.
0.
0.
0.