Table of Contents
Advertisement
9 SYSTEM SET CODES continued
CHANGING SYSTEM SET CODES
To enter a system code of your choice, use the
procedure below.
1. Turn off the radio.
2. Press/release the SYSTEM SET button (20). Note
that '- - ' (51) appears in the upper right corner of
the display and the clock digits disappear.
3. Within 5 seconds, enter the desired numeric
code with the numeric key pad, then immediately
press/release the button labeled SYSTEM SET.
The code ICON (52) will briefly appear in the lower
right corner of the display.
CHANGING THE CLOCK FROM 24 TO 12 HOUR
FORMAT – AN EXAMPLE OF CHANGING A SYSTEM
SET CODE
The instructions below serve as an excellent
example of how to change a system set code, in this
case changing the clock system to a 12 hour format:
1. Turn off the radio.
2. Press/release the SYSTEM SET button. Note that
'- - ' appears in the upper right corner of the
display and the clock digits disappear.
3. Within 5 seconds, enter 12 with the numeric
keypad, then immediately press/release the
SYSTEM SET button. '12H' briefly appears in the
display.
DEFAULT FACTORY SYSTEM SET CODES
When shipped from the factory, the radio's System
Set Code Table is set up as follows. Changes can be
made via the procedure shown in the section titled
CHANGING SYSTEM SET CODES.
• Ten pages with 50 memories each. Code 08.
• 10 KHz AM (MW) tuning rate. Code 10.
• 24 hour clock system. Code 24.
• Rechargeable batteries to be used. Code 28.
• 87-108 MHz FM frequency coverage. Code 87.
MONITORING THE CURRENT STATUS OF SET
CODES AND OTHER SETTINGS
Performing a three second press of the SYSTEM SET
button, with the E10 turned off, allows monitoring
of key set codes and other settings. This information
quickly flashes in the display in the following order.
1. Time format
2. 9 or 10 kilohertz setting
3. FM tuning range setting
4. Timer A's radio frequency
5. Timer B's radio frequency
6. Rechargeable battery milliamp-hour setting
E10
OWNER'S MANUAL
15
Hide quick links:
Advertisement
Table of Contents
