Projector Management Using Snmp - Dukane 9005 User Manual

8. Other Functions

8.2 Projector Management using SNMP

The SNMP (Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network.
NOTE
• It is recommended that SNMP functions are executed by a network
administrator.
• SNMP management software must be installed on the computer to monitor
the projector via SNMP.
Standard MIB (MIB-2)
You can refer the following items defined in system group of Standard MIB (MIB-2).
Item
sysName
sysLocation
sysContact
Enhanced MIB
You can get configuration information by using Enhanced MIB for projectors.
Enhanced MIB for projectors can be downloaded from [Port Settings] page in
Projector Web Control.
Trap
When an error or warning occurs in the projector, a notification can be sent to the
specified address.
In addition to e-mail alert shown in 8.1 Email Alerts (&87), the following
notification can be sent.
Item
Cold Start
Authentication Failure
90
Projector name is set.
The information on where it is located. It has character string
set in sysLocation (SNMP) in Projector Web Control - [Network
Settings] - [Common Setup].
The information on the administrator's contact information. It
has character string set in sysContact (SNMP) in Projector
Web Control - [Network Settings] - [Common Setup].
When the projector is supplied with the power, it works as
below.
• If the STANDBY MODE is set to the NORMAL: the projector's
power status changes from "OFF" to "Standby state".
• If the STANDBY MODE is set to the SAVING: the projector's
power status changes from "Standby state" to "ON (lamp is
turned on)".
( SETUP menu in the Operating Guide).
&
The SNMP access is detected from the invalid SNMP
community.
Description
Description