Connection In Ad Hoc Mode - Dukane 9005 User Manual

2.4.1 Connection in Ad Hoc Mode

Set the following when connecting the projector and the computer in Ad Hoc mode.
Projector setting
[Restriction on plugging and unplugging the USB wireless adapter]
Before you insert or pull out the USB wireless adapter from the projector, turn off
the power of the projector and pull out the power cord's plug from the outlet. Do
not touch the USB wireless adapter that is connected to the projector while the
projector is receiving AC power.
Do not use any extension cable or device when connecting the adapter to the
projector.
1) Attach the USB wireless adapter to the WIRELESS port of the projector.
2) Turn on the projector.
3) Press the MENU button on the remote control or the
control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU > ADVANCED MENU > NETWORK > WIRELESS SETUP
4) Set the following items in WIRELESS SETUP.
･ MODE: ADHOC
･ DHCP
･ IP ADDRESS
･ SUBNET MASK
･ SSID
･ ENCRYPTION
･ CH
As for setting an IP address, refer to "About IP address". (&13)
Select APPLY, then press the ENTER button to reflect the settings.
Computer setting
1) Set IP ADDRESS and SUBNET MASK for the computer according to IP
ADDRESS and SUBNET MASK set for the projector. Set the projector and the
computer so that they can have the same network address.
2) Select SSID set for the projector by following the procedure of wireless
connection of the computer. Enter encryption key by following the computer's
instruction if it is encrypted.
NOTE
• As for the procedure of setting network and wireless connection for the
computer, refer to the manual of computer or wireless LAN device.
2. Connection to the network
15