Macro Button Setup - Universal Remote Control osiris Owner's Manual

Macro Button Setup

Imagine turning on your TV, your DVD player and your surround sound
receiver by pressing a single
button on your Osiris! What would normally take three remotes and
three button pushes, the Osiris can accomplish with the press of one
button. We call that a "Macro". Any of the Display buttons, the Power
On or the Power Off buttons (on any Device or Page) can be set to be
Macro buttons!
To setup a macro button, follow these easy steps:
Enter the SETUP mode by pressing and holding both MAIN and
1
ENT for three seconds.
Note: You have 30 seconds for each step, otherwise the Osiris will time
out automatically.
Press the MACRO button. The top of the display will show
2
"MACRO". The bottom of the display will flash "SELECT".
3 Navigate to the Device and Page where there is a button you would
like to set as a Macro button using the MAIN, DEVICE, and PAGE but-
tons.
Advanced Options:
If you wish to set one of the DEVICE buttons as a macro, on step 3, press the
Page Up button twice. The top of the display changes to MAIN, and you can
navigate to MAIN page 1 or page 2 before going on to Step 4.
Another option for DEVICE button macros is to only send the macro if the but-
ton is pressed and held. This is setup by entering a delay as the first step of the
macro. The amount of delay determines how long the user must press the but-
ton before the macro is sent. The advantage of this option is that a normal
press of the DEVICE button will simply switch devices without issuing the
macro.
4
Press the button you want to set as a Macro
button. The top of the screen will display the label of the button
you selected. At the bottom of the screen it displays "STEP0", indi-
cating that no macro steps have been entered yet.
M X - 3 5 0
19