Universal Remote Control osiris Owner's Manual page 32

RF Settings Overview
The Osiris is factory set to work out of the box with an MRF-100 base sta-
tion, which is not addressable. The only setting that affects operation with
an MRF-100 is the RF/IR setting (to operate, the Osiris must be set to IR/RF
or RF- it will not operate the MRF-100 in IR mode). The Osiris will operate
with an MRF-200 or MRF-300 base station set to ID#0 with the factory
default settings. However, in order to gain the advantages of addressable
base stations (no interference between systems within one house or a
condo development with potential interference between two different con-
dos, turning the front blaster on or off, or routing identical commands to a
stack of identical televisions or satellite receivers etc.) you must reset the
Osiris and the Base Station ID# to any address other than ID#0. ID#0 is an
"open door" to any RF signal, it is not a true address. It is extremely useful
for testing whether any interference is present, since the base station's STA-
TUS LED will flicker if interference is present. Once the base station is
moved to a location where the LED does not flicker, the ID# can be
changed to one of the other addresses.
Note that ID#0 does not allow any emitter or blaster configuration. Before
changing any emitter or blaster settings, you must reset the ID# to an
address other than 0. ID#0 does not allow you to change emitter or blaster
settings. Here are the factory default RF settings of the Osiris:
IR/RF (Type of Signal) - All devices are factory set to send both an IR line of
ID# (Base Station Address) - All devices are factory set with ID #0.
EMITT (IR Emitter Line Output) - All devices are factory set to output IR com-
BLAST (Base Station Front Panel Blaster) - The blaster is factory set to be on.
Changing the RF Settings
Enter SETUP mode by pressing and holding both MAIN and ENT
1
for three seconds.
Note: You have 30 seconds for each step, otherwise the Osiris will time
out automatically.
Press the PAGE buttons until page three of Setup is displayed (RF is
2
the only choice on Page 3).
O s i r i s
sight signal and an omnidirectional RF signal.
mands through ALL IR Emitter Line Outputs.
30