Cloning One Osiris To Another - Universal Remote Control osiris Owner's Manual

Erasing the Entire Osiris
To erase EVERYTHING, press and hold both the MAIN and the STOP
buttons for 15 seconds. After 15 seconds, the RESET screen appears.
Press the SURE button to erase all of your settings and return to the fac-
tory default setup.

Cloning One Osiris to Another

If you own two or more Osiris, you can copy and transfer all the setup
from one Osiris to another. Just follow these easy steps:
Enter SETUP mode by pressing and holding both MAIN and ENT
1
for three seconds.
Note: You have 30 seconds for each step, otherwise the Osiris will time
out automatically.
2
Press a PAGE button to display page two of Setup.
3
Press the CLONE button.
4
Align the two Osiris head-to-head, about an inch apart.
Press the RECV display button on the new Osiris you would like to
5
setup by cloning.
6
Press the SEND display button on the Osiris you previously setup.
Press the START button on the new Osiris and then press the
7
START button on the Osiris you previously setup.
Note: Cloning typically takes about 40 seconds.
After completion, the cloned Osiris will flash "GOOD".
8
Return to normal operation by pressing the MAIN button twice.
O s i r i s
26
SURE
Button