Table of Contents
Advertisement
Quick Links
Pro Series 3
VHF Wireless Systems
Installation and Operation
PRO-301
UniPak
Transmitter System
®
PRO-301/G
Guitar System
PRO-301/H
Headworn Microphone System
PRO-301/H92
Miniature Headworn Microphone System
PRO-301/H92-TH
Miniature (beige) Headworn Microphone System
PRO-301/L
Lavalier Microphone System
PRO-302
Handheld Microphone System
Advertisement
Table of Contents
Related Manuals for Audio Technica Pro Series 3
Summary of Contents for Audio Technica Pro Series 3
- Page 1 Pro Series 3 VHF Wireless Systems Installation and Operation PRO-301 UniPak Transmitter System ® PRO-301/G Guitar System PRO-301/H Headworn Microphone System PRO-301/H92 Miniature Headworn Microphone System PRO-301/H92-TH Miniature (beige) Headworn Microphone System PRO-301/L Lavalier Microphone System PRO-302 Handheld Microphone System...
-
Page 2: Receiver Installation
For best performance, locate the receiver so its antennas are in direct line-of-sight to the transmitter’s likely operating position. Because Pro Series 3 packaging is designed to hold all versions of the system, some compartments in the carton are intentionally left empty. -
Page 3: Receiver Controls And Functions
Pro Series 3 Installation and Operation Receiver Controls and Functions Figure A — Front Panel Controls and Functions 1. ANTENNAS: Position the “signal” antenna (1a) and “ground” antenna (1b) as shown to the right and above right. Fully extend both antennas by pulling on the endcaps. - Page 4 Pro Series 3 Installation and Operation Transmitter Setup, Controls and Functions Battery Selection and Installation An alkaline 9-volt battery is recommended. Make certain the transmitter power switch is Off before installing or changing batteries. When inserting the battery, observe correct polarity as marked inside the battery compartment.
- Page 5 Pro Series 3 Installation and Operation Microphone Trimmer (MT) Guitar Trimmer (GT) Battery-Save Switch (under screwdriver clip) Battery Compartment Figure D — UniPak Transmitter ® UniPak ® Transmitter Battery Installation 1. Slide off the battery cover as shown in Figure D.
-
Page 6: System Operation
Pro Series 3 Installation and Operation System Operation Return the screwdriver to its clip and close and secure the lower body. No further transmitter gain adjustments should be needed, as long as the acoustic input does not change significantly. Turn down the receiver volume control and the mixer/amplifier level before starting up the wireless system. -
Page 7: Specifications
Pro Series 3 Installation and Operation System Operating Frequencies Application Freq. Code Freq. (MHz) • Traveling frequencies: 169.505 (Normally work anywhere in the U.S.A. and 170.245 Canada.) Not all frequencies available in all areas 171.905 outside the US. Please check with local regulations. - Page 8 Audio-Technica U.S., Inc. 1221 Commerce Drive, Stow, Ohio 44224 USA +1 (330) 686-2600 Audio-Technica Limited Old Lane, Leeds LS11 8AG England +44 (0) 113 277 1441 Audio-Technica (Greater China) Limited Unit K, 9/F ., Kaiser Est. (Ph.2) 51 Man Yue St. Kowloon, HK. +852-2356-9268 Audio-Technica (S.E.A.) Pte.