Adjusting Character (Bidirectional) Alignment - Lexmark 2500+ Series User Manual

Troubleshooting
Control panel lights
Power
Ready
Paper Out
Font Lock
All lights on solid
Panel Lock
Power
Ready
Tractor 2
Paper Out
Font Lock
Power
Ready
Paper Out
Panel Lock
Font Lock
Power
Ready
Tractor 2
Paper Out
Panel Lock
Font Lock
Power
Ready
Tractor 2
Paper Out
Panel Lock

Adjusting character (bidirectional) alignment

Occasionally, you may want to adjust the character alignment (also called bidirectional alignment) on your printer. The
following steps show how to adjust the alignment of the print wires.
Notes:
•
Make sure continuous forms are loaded in the printer.
•
Make sure the factory default setting for the Uni‑Dir Printing menu option is set to Off (bidirectional).
•
Make sure the default macro is set to Disabled. For more information, see
1
Press and hold Start/Stop for five seconds.
2
Open the control panel cover to access layer 2.
3
Press and hold Pitch, and then press Start/Stop.
Status
On
Blinking
Blinking
Blinking
On
Blinking
On
Blinking
Blinking
Blinking
Blinking
On
Blinking
Blinking
Blinking
Blinking
On
Blinking
Blinking
Blinking
Blinking
Blinking
On
Blinking
Blinking
Blinking
Blinking
Action required
Unplug the printer power cord, and then plug it again to
the electrical outlet.
Notes:
•
If the control panel light sequence returns, then
contact Customer Support.
•
If you need help locating the nearest service
representative, then visit www.lexmark.com.
"Forms Macro options" on page
64
50.