Operation; Deleting A Preset Channel; Scanning; Programming Scan Memory - Standard Horizon HX300E Owner's Manual

6.6.2 OPERATION

1. Press the
" " icon and Preset Channel Number will ap-
pear on the display.
2. Press the
Channel (" P0 " ~ " P9 ").
3. Press the
channel. The "
display.

6.6.3 Deleting a Preset Channel

1. Press the
2. Press the
nel to be deleted.
3. Press and hold the
blinking.
4. Press and hold the
cation is removed from the display.
5. Repeat steps 2 through 4 to delete the desired chan-
nels from Preset Channels " P0 " ~ " P9 ".
6. To finish the deleting the Preset Channel, press the
turn to the last selected normal channel.

6.7 SCANNING

The HX300E allows the user to select the scan type from "Memory Scan" or
"Priority Scan". "Memory Scan" scans the channels that were programmed
into Scan Memory and also channels stored in the Preset Channel (" P0 " ~
" P9 "). "Priority Scan" is similar to the "Memory Scan" scan, however it scans
the priority channel (channel 16) and dual watches to channels programmed
in memory scan and preset channel memory. When an incoming signal is
detected on one of the channels during scan, the radio will pause on that
channel, allowing you to listen to the incoming transmission.

6.7.1 PROGRAMMING SCAN MEMORY

1. Turn the transceiver off by press and holding the
key.
2. Hold down the
ceiver while still holding down the
will appear on top right of the display.
3. Press the
be scanned, then press the
pears on the display, which indicates the channel has
Page 24
key to recall the Preset Channel. The
or key to select the desired Preset
key again to return to the last selected
" icon will disappear from the
key to recall the Preset Channel.
or key to select the Preset Chan-
key until the "
key until "
key, and then turn on the trans-
or key to select desired channel to
" icon is
" icon indi-
key. " " icon
key. The " " icon ap-
key again to re-
HX300E