Electrical Service And Repair; Junction Box Installation - Heat & Glo SOLARIS36-ST Owner's Manual

LIGHT
CONTROL
BLK
NOTE: The chart below show the colors produced
when light control is wired and orientated as shown
in this wiring diagram.
SWITCH TRIPPED
RED
BRN
BLU
RED/BRN/BLU
RED/BRN
BRN/BLU
RED/BLU
Figure 12.3 LED Wiring Diagram
E. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
F. Junction Box Installation
• Remove the screw attaching the junction box/receptacle
to the outer shell, rotate the junction box inward to dis-
engage it from the outer shell. See Figure 12.4.
• Pull the electrical wires from outside the appliance through
the opening into the valve compartment and secure wires
with a Romex connector. See Figure 12.4.
• Remove the knockout from the front of the junction
box.
• Pull the electrical wires through the knockout and secure
the wires with a Romex connector. See Figure 12.4.
50
6 LEAD WALL CONTROL WIRE
APPLIANCE
ON/OFF
CONTROL
RED
WHT
BRN
WHT
BLU
COLOR PRODUCED
GREEN
RED
BLUE
WHITE/CLEAR
YELLOW
PURPLE
LIGHT BLUE
Heat & Glo • Solaris • 2179-900 Rev. E • 4/11
LED STRIP ASSEMBLY
L.E.D CONTROL HARNESS
2 1
WHT
WHT
PLUG IN
TO WALL SWITCH
JUMPER WIRE
POWER SUPPLY
PLUG IN
NEUTRAL
HOT
• Make all necessary wire connections to the junction box/
receptacle and reattach the junction box/receptacle to
the outer shell.
Figure 12.4 Junction Box Detail
NOT USED FOR
THIS MODEL
JUNCTION BOX
NOTICE: DO NOT wire
110 VAC to wall switch.