Heat & Glo 6000C-LP Owner's Manual page 65

2 2
HORIZONTAL GRATE BAR HORIZONTAL GRATE BAR
Figure 7
Log #3 (SRV2168-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been fi tted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and far right grate tine. Log # 3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7).
Log #4 (SRV2168-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to
left under Log #2 to fi t completely and securely into the indentation (see Figure 8). The back or Log # 4 should rest against
the far left grate tine as well as contact Log # 2.
FLAT AREA FLAT AREA
2 2
4 4
Figure 9
Log #5 (SRV2168-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log fi ts
completely and securely in the indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.
Log #6 (SRV2168-706): Mate the groove located on the lower end of Log #6 with the fourth tine (from left to right) as
shown in Figure 10. Set the other end of Log #6 on the fl at area located on top of Log #4 (see Figure 9). Log #6 will
also rest against center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing
movement or shifting.
RIGHT GRATE TINE RIGHT GRATE TINE
1 1
3 3
1 1
3 3
5 5
Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. Q • 11/11
2 2
4 4
LOG #4 CONTACTS LOG #2 LOG #4 CONTACTS LOG #2
Figure 8
LOG #6 CONTACTS TOP OF LOG #4 LOG #6 CONTACTS TOP OF LOG #4
2 2
6 6
4 4
Figure 10 LOG CONTACTS GRATE TINES LOG CONTACTS GRATE TINES
1 1
3 3
1 1
3 3
5 5
2168-935C
65