Mounting; Orientation; Rigging - Chauvet LED PAR 64-36B User Manual

Mounting

Orientation

The LED PAR 64-36 B/C may be mounted in any safe position provided there is adequate room
for ventilation.

Rigging

Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the fixture securely.
This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13
mm in size. When rigging consider routine maintenance and control panel access. Please see
the following steps for installation.
Secondary bracket
(used primarily for
standing position)
Do not use a tool
adjustment knob
3. Setup
Be sure to orient the gel frame release so that it is pointing up. Please see the diagram
below for a visual reference.
If the power link out is intended to be used with multiple fixture, take into account the length
of each power cable, and mount the fixtures close enough to one another to accommodate
for this.
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
There is a secondary portion of the bracket, which may be used primarily for floor standing
positions.
Safety cables must always be used.
Mounting
Bracket
on the bracket
Aim the fixture with
the gel frame
release pointing up,
(as shown in this
diagram)
9 10/27/2009 1:10 PM