Rub Collars - Grizzly G8621 Instruction Manual

Heavy-duty sliding table shaper
Hide thumbs Also See for G8621:
Table of Contents

Advertisement

Rub Collars

Rub collars are used when shaping curved or
irregular workpieces, such as arched doors or
round table tops. Rub collars also limit the depth
of your cut.
There are two types of rub collars—solid and ball-
bearing. We recommend against the use of solid
rub collars. Grizzly carries an extensive line of
ball bearing rub collars designed for use with
Grizzly shapers. See the current catalog for list-
ings.
Rub collars may be used in any of the following
positions:
1.
Rub collar below the cutter: When the rub
collar is used below the cutter as shown in
Figure 38, the progress of the cut can be
observed. However, any unintentional move-
ment may lift the workpiece into the cutter,
damaging your work and creating a danger-
ous situation that may result in kickback. We
do not recommend using the rub collar below
the cutter.
Figure 38. Rub collar installed below cutter.
Whenever the cutterhead is above the
workpiece, or you can see it spinning dur-
ing use, you must take extreme caution to
keep your hands away from the cutterhead.
Failure to do so may cause serious per-
sonal injury.
G8621 Heavy-Duty Sliding Table Shaper
2.
Above the cutter: When the rub collar is
used above the cutter as seen in Figure 39,
the cut cannot be seen. This offers some
advantage: the stock is not affected by slight
variations in thickness and accidental lifting
will not damage the workpiece. If lifting
occurs, simply correct the mistake by repeat-
ing the operation.
Figure 39. Rub collar installed above cutter.
3.
Between two cutters: Using a rub collar
between two cutters, as in Figure 40, has
the distinct advantage of performing two cuts
at once or eliminating the need to change
cutters for two different operations. Notice
that part of the edge is left uncut. The uncut
portion rides on the rub collar.
Figure 40. Rub collar between two cutters.
-27-

Advertisement

Table of Contents
loading

Table of Contents