Installing The Console - Life Fitness F3 Assembly & User Manual

2.4 I C
NSTALLING THE ONSOLE
Remove the pre-installed bolt (A) from the back of the
main console (B). Position the main console near the top
of the console bridge and attach the connectors leading
from the console bridge to the corresponding tabs on the
back of the main console. The wires are color wrapped to
match colored tabs on the main console circuit board. The
main console harness (C) wrapped in a green sleeve
corresponds with the green tab on the console circuit
board. The Activity Zone harness (D) wrapped in a yellow
sleeve corresponds with the yellow tab on the console
circuit board. The grounding wire (E) is the small green
and yellow wire that inserts onto either of the two metal
circuit board receptacles.
Be sure the connectors are fully seated together. Feed
any excess wire into the console bridge.
Attach the main console to the console bridge using three
M8 x 25mm ZINC BOLTS (6). Tighten the bolts
6
securely.
CAUTION: Do not pinch the wires when attaching the
main console to the console bridge.
Securely tighten all the bolts that were left finger-tight.
14