Rabbet Operations - Grizzly G5959 Instruction Manual

Dadoing operations can also be accomplished
using a conventional saw blade. To create a sin-
gle-blade dado:
1. Clearly mark the width of the dado cut on
your workpiece. Include marks on the edge
of your workpiece so you can clearly identify
your intended cut while the material is laying
flat on the saw table.
2. Set the blade height to the depth of cut you
wish to create.
3. If the dado runs the length of the material,
adjust the fence so the blade is aligned with
the inside of your dado channel as shown in
Figure 39.
4. Turn on your saw and make the first cut.
Figure 39. Single-blade dado cut.
5. Turn off the saw and re-adjust the fence so
the blade is aligned with the other edge of
the intended dado channel. Be sure to keep
the cuts within your marks; otherwise, your
dado will be too large.
6. Turn on the saw and make a second cut.
7. Move toward the center of the dado with your
subsequent cuts until the dado is complete.
8.
Reinstall the blade guard.
-30-
Fence
Wood Stock
Saw Blade

Rabbet Operations

In addition to its ability to create a variety of
dadoes, this table saw can be used to cut L-
shaped rabbets. These cuts can be created with
a regular saw blade or with specially designed
stacking or wobbling dado blades.
Proper rabbet operations will differ depending on
the blade system you choose. Consult the
instructions included with your dado blades for
directions regarding attachment and adjustment.
To use a dado blade for rabbeting operations:
1. Rabbet cutting on the edge of a piece of
stock requires the use of a sacrificial fence
attachment as shown in Figure 40. The
sacrificial fence can be made from a piece
of wood that is as long as the metal fence
3
and ⁄ " thick. Once the sacrificial fence has
4
been cut, attach it to the metal fence with
screws or clamps, making sure they are all
secure and tight.
Rip Fence
Blade Cut-Out
Figure 40. Sacrificial fence.
G5959/G9957 12" Table Saw
Sacrificial Fence
Dado Insert