Display Mode Set Up - Elation DMX Operator Pro User Manual

8.5 Pan / Tilt Fade Set Up (Cont.)
(3) Press the "Record" button to enter the P/T FADE ONLY option. The LCD will display
the following:
(4) Use the "UP" button to scroll through the FIXTURE # list and use the "DOWN"
button to change the desired fade setting- "ALL or ONLY".
(5) Repeat step 4 until you've completed the fade settings for all desired fixtures.
(6) Press "RECORD" to confirm and store your new settings.
(7) Press the "ESC" button two (2) times to exit.

8.6 Display Mode Set Up

The Display mode set up allows you to go in and change the way channels read out on the display.
You have two options- one is "MODE:255" and the other is "MODE:100". MODE:255 will display
channel settings in values- between 0 – 255. MODE:100 will display channel settings in
percentages- between 0 – 100%. The factory setting is "MODE:255". If you wish to change this,
follow these steps.
(1) Press and hold down the "SETUP" button for three (3) seconds or until the green
LED above the SETUP button comes on. The LCD will display the following with a
cursor box flashing over the # 1 option.
FIXTURE1: ALL
OK ESC SEL ADJ
1
. CF CARD
2. ASSIGN CH.
DMX OPERATOR PRO
↓
36