Wdmx Internal Wireless Dmx Receiver Set Up - Elation PLATINUM SPOT 35 PRO User Manual

Table of Contents

Advertisement

W D M X I N T E R N A L W I R E L E S S D M X R E C E I V E R S E T U P
The PATINUM SPOT 35 PRO™ is equipped with an internal Wireless DMX Receiver,
which is fully compatible with an Elation Wireless DMX System. Access the "Wireless
DMX" sub menu from the "PERSONALITY" menu, and then select the desired WDMX
connection function, which includes:
WDMX Off - Turn OFF Wireless DMX
Activate WDMX - Turn ON Wireless DMX
Act & Data Out - Turn ON Wireless DMX and send DMX data to wired 3/5pin outputs
Clean WDMX Memo - Clear WDMX memory
When the WDMX system is "Activated" the internal DMX "IN" XLR jacks are OFF.
However the internal DMX "OUT" XLR jacks will function normally. If the fixture is
powered ON with the internal WDMX system "Activated", it will automatically scan
for a wireless DMX signal from an Elation Wireless Transmitter.
If NO wireless signal is received, it will electronically switch to the wired DMX mode.
NEVER connect a fixture to a controller via a DMX cable when the WDMX
system is in use. This could cause serious damage to the controller!!
SETTING UP THE WDMX SYSTEM
Follow the instructions included with the Elation EWDMX Transmitter and connect it
to the output of your DMX controller.
To sync your fixture with the Elation EWDMX Transmitter follow the steps below
Initially, the Wireless Indicator on the fixture control panel should be solid RED.
Press and hold the configuration button on your EWDMX Transmitter for about 3
seconds. The
RED/GREEN
should begin to flash rapidly for about 5-10 seconds while the two systems pair.
Once the fixture is paired with the EWDMX Transmitter (T1), the Wireless status
indicators on the both the fixture and the EWDMX Transmitter will stop flashing
and glow solid GREEN. If paring is unsuccessful repeat the process until paring is secured.
The fixture will store the pairing information inside a nondestructive memory bank
once a link is created between the fixture and an EWDMX Transmitter. The fixture
will remember the paired EWDMX Transmitter even if the fixture is turned OFF for
extended periods of time.
 
w w w . e l a t i o n l i g h t i n g . c o m
W A R N I N G !
LED indicators on the EWDMX Transmitter and the fixture
         
35
PLATINUM SPOT 35 PRO™ User Manual Version 1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents