Installation Instructions - AEG Electrolux KB9810E User Manual

Electric built-in oven
Hide thumbs Also See for KB9810E:
Table of Contents

Advertisement

48
Problem
The microwave is not
working
The oven lighting is not
operating
"d" is lit in the display
and the oven is not heat-
ing up. Fan not operating
If you are unable to remedy the problem by following the above suggestions, please
contact your dealer or the Customer Care Department.
WARNING!
Repairs to the appliance must only be carried out by qualified service engineers. Consid-
erable danger to the user may result from improper repairs.
In the event of incorrect operation, visits by engineers from Customer Service or the dealer
may be chargeable, even during the warranty period.
Information for appliances with metal fronts: Due to the cool front of your appliance, there
may be short-term condensation of the inner door glass after opening the door, during or
shortly after baking or roasting.

Installation instructions

CAUTION!
The new appliance may only be installed and connected by a registered installation engineer.
Please comply with this instruction. If you do not, any damage resulting is not covered by
the warranty.
To prevent future hazards, damaged mains cables must only be replaced by a qualified
electrician.
Possible cause
The required settings have not
been made
The oven's automatic switch-off
has been triggered
The child safety device is activated. Switching off the child safety de-
The fuse in the house's electrical
wiring (fuse box) has been tripped
The oven door is not properly
closed
The door seals and door seal sur-
faces are dirty
The Start button was not touched Press the Start button
The oven light bulb is faulty
Test mode is switched on
Remedy
Check the settings
See Automatic switch-off
vice
Check fuse. If the fuses trip several
times, please call a qualified elec-
trician
Close the oven door
Clean door seals and door seal sur-
faces
Replace oven light bulb
Switch off the appliance. Press and
hold the
and
buttons at the
same time, until signal sounds and
"d" display goes out.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents