Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking the chain tension
9.18
Warning
Danger of accidents Danger caused by incorrect chain tension.
–
If the chain is over tensioned, the components of the secondary power train (chain, engine sprocket, rear sprocket, bearings in
transmission and rear wheel) are under additional load. Apart from premature wear, in extreme cases the chain may snap or the
countershaft of the transmission can break. On the other hand, if the chain is loose, it may jump off the engine sprocket or the
rear sprocket, causing the rear wheel to lock or damage the engine. Check for correct chain tension and adjust if necessary.
B
0 0 B
A
0 0 A
–
Lean the motorcycle on the side stand.
–
Shift the transmission to neutral.
–
Push the chain upwards near the lower chain guard screw and measure chain
tension
.
Info
The upper chain section
Chain wear is not always even, so you should repeat this measurement at differ-
ent chain positions.
400620-10
Chain tension
»
If the chain tension does not meet specifications:
–
Adjust the chain tension. (
must be taut.
35... 40 mm (1.38... 1.57 in)
p. 82)
81
Advertisement
Table of Contents
